HF-Sendeleistungsverstärker

VHF Endstufe 140-150 MHz. mit Lüfter • Stromversorgung 12-14 Volt • Stromaufnahme 14 Ampere • Eingangsleistung 1-25 Watt • Ausgangsleistung 120 Watt max. • SWR Betrieb max. 1.1-1.5 • FM-SSB-CW Mode • Vorverstärker 18-26 dB • LED Ausgangsleistungsanzeige • Elektronische Umschaltung • Schutzvorrichtung gegen Oberwellen und Verpolung • Aluminiumgehäuse • Abmessungen: 170 x 190...

VHF Endstufe 140-150 MHz mit Empfangsverstärker. Technische Daten Frequenzbereich 140-150 MHz Eingangsleistung 1-50 Watt max. max. Ausgangsleistungen max. 250 Watt Modulationsarten FM,SSB,CW Stromversorgung 13,8 Volt DC, ca. 30 Ampere Transistoren Typ Anschlüsse Abmessungen 170 x 275 x 62mm Gewicht 1400g Besonderheiten eingebauter Vorverstärker 18-26dB Ventilator...

Midland HF 747 Verstärker - 100 W AM/FM, 200 W SSB PEP Ausgangsleistung. Benutzung nur von lizenzierten Funkamateuren erlaubt. Technische Daten: Modell HF747 Frequenzbereich HF Stromversorgung 12-14 Vcc Frequenzbereich 20-30 MHz Stromverbrauch 8-10 A Eingangsleistung 0,5 W - 10 W Ausgangsleistung max. 100 W AM/FM, 200 W SSB PEP Betriebsarten AM-FM-SSB-CW Sicherung 1 x12 A...

10W in 160W out 2 Meter VHF Amplifier w/ FM/SSB/CW Modes & GaAsFET Pre-Amplifier Input Power Range: .25 - 15. I (MAX) at 13.8 Volts: 25. Weight Pounds: 5. Size WxHxD inches: 12x3x5.5. PreAmp Gain: 20 dB. Typical Power Out for Watts in: .25: 15. 0.5: 30. 1: 60. 2: 100. 3: 130. 5: 150. 6: 153. 8: 155. 10: 160. 15: 160+.

2W in 35W out 2 Meter VHF Amplifier with FM Mode 35 Watts out for 2 watts in. Similar to B-34-G but FM only, less preamp, mobile bracket

2W in 25W out 150-174 MHz VHF Commercial HT Amplifier w/ FM Mode Mirage's B-34-GC is a two-way radio signal amplifier (or booster) designed for commercial mobile or fixed location use. This amplifier is a specifically designed to boost the range of low power (less than 3 Watts output) mobile or handheld two-way radios by increasing output power nearly ten times. This unit...

Einbauhalterung für KL-Verstärker • Seitenmontageschiene inkl. Befestigungsmaterial und Schrauben.

2W in 82W out 70 cm/430-450 MHz UHF Amplifier w/ FB/SSB/CW/ATV Modes RF POWER IN: 500mWatts to 5 Watts RF POWER OUT: 52 Watts CURRENT: 20 Amps SIZE: 12x3x5.5 inches WEIGHT: 6 pounds

15 W in - 100 W out, FM, 450-470 MHz

-4W in 110W out 6 Meter Repeater Amplifier w/ FM/SSB/CW Modes Specifications: Input Power Range: 0.25-5.0 I (MAX) at 13.8 Volts: 20.0 Heatsync. PreAmp Gain: NO. Typical Power Out for Watts in: 0.25: 6.0 0.5: 10. 1: 22. 2: 42. 3: 63. 5: 98.

10-12 Watt in - 120 W out, FM/SSB/CW, 145-148 MHz Cool Running 10" high by 19" wide full finned rack mounted heatsink keeps the transistor temperatures low for long life. The chassis cover is perforated so air convection will keep the circuit board area cool. The RF board is low loss. PTFE for minimum dielectric heating. Reliable The RF change-over relay has been eliminated...

10W in 82W out 70 cm/430-450 MHz UHF Amplifier w/ FM/SSB/CW/ATV Modes. 10 Watts in - 52 Watts Out (ATV-AVG) 10 Watts in - 82 Watts Out (ATV-PEP) 10 Watts in - 100 Watts Out (SSB/FM) Specifically designed for amateur television 420 - 450 MHz RF Power In: 1 Watt to 15 Watts RF Power Out: 100 Watts (SSB/FM), 52 Watts (ATV) Current: 20 Amps Size: 12" x 3" x 5.5" Weight: 6 lbs.